Go | New | Find | Notify | Tools |
Location: California Registered: 13 September 2005 Posts: 351 | Is it okay to use a 10% lactic acid gel, one that you rinse off after a few minutes and then use the Skin Signals Cream right after. Thank you Di |
Location: SkinBioOffice Registered: 23 December 2009 Posts: 535 | Dear Di, It would be better if you used them at opposite ends of the day. Chances are even though the lactic acid gel is rinsed off, it could damage the GHK-copper in the Skin Signals Cream. The Skin Signals Cream combines GHK-copper plus copper peptides produced from collagen and elastin fragments. Skin Signals Cream can be damaged by use with hydroxy acids and should be used alone. Best Wishes ~The SkinBio TeamThis message has been edited. Last edited by: Skin Biology, |
Location: California Registered: 13 September 2005 Posts: 351 | Thank you Skin Biology Team |
Location: Illinois Registered: 09 June 2008 Posts: 196 | Can Skin Signals Cream be used at the same time of day as retinoids like Retin A or Tazorac? |
Location: Skin Biology Registered: 15 September 2004 Posts: 7065 | Yes. |
Location: Skin Biology Registered: 15 September 2004 Posts: 7065 |
Unless this lactic acid gel is at a very low pH, it is not going to do much in 10 minutes. |
Location: California Registered: 13 September 2005 Posts: 351 |
Dr. Pickart The 10% lactic acid gel I have is a 1.9 pH. I used it last year about once every 2 weeks and I only left it on for about 2 min. at the most. But now that I have a sample of your Lactic Power 10 I will be using that instead. If I use the Lactic Power 10 will it give me the same results as using a 10% lactic acid gel once every 2 weeks? Also will the Lactic Power 10, help the Skin Signals Cream work better? I haven't used any exfoliation all summer because I'm very light and sun sensitive. I seem to be getting more fine lines in the mouth area in the last few months. Do you think I also need to use TriReduction cream in that area too? Thank you Di |
Powered by Social Strata |
Please Wait. Your request is being processed... |